Lace Entrance Wigs, Full Lace Wigs, Lace Wig, Full Lace Wig, Lace Entrance Wig
First issues first…PREPARATION…PREPARATION…PREPARATION!!!
Bookmark http://www.lhboutique.com/catalog/index.php cPath=24_80 and tell a buddy!
-Collect your software products for easy accessibility and put together your individual hair by either braiding into small cornrows, pin curling temporary hair loss solution or wrapping your hair tightly. The primary goal is to get your hair as flat as possible. Carrying a wig Cap is non-compulsory.
-Pin and clip all of the hairs in your unit (especially the baby hairs) away from the edges of the wig’s perimeter.
-Apply Fray Block to lace as directed on packaging and permit to dry. (Non-compulsory) Please be aware that Fray Block will help stop your lace from fraying. Fray block should dry clear.
-Fastidiously lower additional lace around the perimeter of the wig to the place the hair is knotted, being careful not to chop into the child hairs.
-Apply alcohol or cleanser with a makeup sponge to clean pores and skin across the edges of your natural hairline. The goal is to remove all excess oils from your pores and skin. If you have any issues about wherever and how to use weave, you can speak to us at the web site. Apply scalp protector to area to be bonded. Let dry.
Position the lace wig on your head. Use an eyebrow pencil, flippantly trace the hairline of the wig onto your forehead.
Using an software brush or q-tip, apply adhesive simply beyond your hairline as instructed by the lace wig adhesive manufacturer. Once the glue is ready (this will rely upon the glue kind) place lace wig in your head with hairline rolled again. Starting at the center point of your forehead, bond wig to head by urgent down on one aspect, then the other, using the tip of a tail comb. Bond front hairline first, then nape. Use the back end of comb to press tougher additional securing lace entrance wig onto hairline. Permit time for glue to completely cure/dry before styling. (usually 24 hours) All can be discovered at http://www.lhboutique.com/catalog/index.php cPath=25 Tie the edges of hair with a silk scarf till glue has totally set / cured.Utility with Adhesive/Tapes
Put together the lace wig, hair and skin as previously talked about above.
Reduce the tape into desired shapes and attach firmly around the perimiter of the lace unit.
Full Lace Wigs and Lace Entrance Wig accessories temporary hair loss solution can all be discovered at http://www.lhboutique.com/catalog/index.php cPath=25
Place the unit in your head. Take away the backing of the tape in sections, a bit at a time. Beginning from the center of the forehead, firmly press tape into pores and skin with a tail comb.
Tie the edges of the hair with a silk scarf till the adhesive has set.
To acheive a longer hold, mix the use of liquid and tape adhesives. The tape helps preserve the lace by protecting it from frequent wear and tear. For tape/glue software, first apply glue to hairline, then apply tape to the front and nape of the wig. Press tape into wig firmly. When glue is prepared, remove backing of tape and press the lace down into skin using a tail comb.
Be sure to go to http://www.lhboutique.com/catalog/index.php cPath=24 to check out our SUPERIOR Quality selection of Full lace Wigs and Lace Entrance Wigs.